Mikrotron MC132x Spécifications télécharger pdf (Page 9)

Hardware MC132x Users Manual Rev. 0.22

3 Hardware

3.1 GigE Vision® Interface

GigE Vision® is designed for digital cameras in machine vision applications. This interface can transfer

data at a rate of 110 Mbytes/sec.

3.1.1 Serial interface

3.2 Power supply

The camera needs a DC supply voltage between 8 … 24 V at a power consumption of 5,0 Watt max.

See also Connector pinning .

Before applying power to the camera we strongly recommend to verify the used pins of the

power connector, the polarity (+/-) of the leads and the supply voltage.

The camera may only be used with a supply voltage according to the camera specification.

Connecting a lower or higher supply voltage, AC voltage, reversal polarity or using wrong

pins of the power connector may damage the camera. If doing so, the warranty will expire

immediately.

3.3 Status LED

A dual colour LED on the camera backplane shows the operating condition of the MC132x.

LED orange... The MC132x is configuring the internal FPGA. No other activity is possible.

LED green... The MC132x is fully operational.

LED off... If LED is off, despite the camera is powered, the FPGA configuration data is re-

loaded via the serial interface and stored in internal EEPROM. No other activity

is possible.

LED red... red LED that the FPGA could not be loaded because of wrong FPGA configura-

tion data. Try to

reload configuration data.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 44 45

Pas de commentaire

Mikrotron MC132x Spécifications Page 9